Lancaster Table & Seating Clear Metal Frame Chair Glide - 4/Pack

It would be helpful if the website had the actual dimensions listed for the barstool feet. I had to order both the Lancaster and BMF just to see which would fit. Both are designed to fit 1.25 inch (or 1-1/4") outside dimension square tube. However, this is where it gets tricky. The tube thickness will vary, some are thick wall metal tubes, some are thin wall (typical of Chinese brands). To simplify, these will both fit a 1-1/6" to 1-1/8" opening. The Lancaster fits a bit more snug, the BMF was slightly smaller so it fits loose. If they are still too loose, wrap it a couple of times with electrical tape. Hope this helps.

Slips on to legs of a dining chair and protects floors from damage from constant moving of chairs. This cheap item can save you the cost of expensive repairs

the price is right for these. they fit well. i wish the plastic was a bit harder so they would last longer. they seem to wear down quickly.

These chair glides are an absolute necessity for bar stools and dining chairs to protect the floor. Easy to install with a hammer. Make sure the old ones are completely removed. Over time, they do wear down but that's to be expected with all the wear and tear of moving chairs in and out.

After letting webstaurant know that 3 of our bar stools were delivered without the chair glides, they were quick to send us a box of replacement glides that were easy to tap right in. Thank you for quickly solving this problem.

Slips on to legs of a dining chair and protects floors from damage from constant moving of chairs. This cheap item can save you the cost of expensive repairs.

Lancaster Table & Seating Bistro Chair Glide is a necessity for anyone who cares about the appearance of their floors and wants them to last longer

So I got one of these to try and my bistro chairs they fit without a problem just got up top and middle bit with a hammer the only downside is The rounded on the bottom and not flat and all mine are flat but I might just go ahead and replace them all

These are perfect and exactly what I needed. I replaced all the bottoms of all my chairs with these, no more rocking chairs and the customers are happier!

perfect fit and the cost was very low for these glides. work as they should and very easy to install. great product for the cost.

Perfect for the replacement of the bottoms of our commercial dining room chairs. They are life savers as the original chair gliders start to fall off. They insert very easily with a slight tap of a rubber hammer. No scratching or scuffing of our floors.