Lancaster Table & Seating 22" Round Black 4 1/2" Bar Height Column Table Base

Assembling your restaurant table base can be done with ease by following a few quick steps! Begin by placing your threaded rod through the hole in the spider, until the end of the rod sits in the top of the spider. Flip this over to then place the column over the threaded rod, and slide it down until it touches the spider. Align the center of the base with the column, and push the end of the threaded rod through the hole in the base. Place the washer and the nut on the threaded rod, and use a wrench to screw the nut into place. When screwing the nut in, make sure that the top of the threaded rod is tight against the spider, which will help to ensure that your base will be stable. Screw the glides into the bottom of the base to finish up the assembly. The first thing you’ll do is to take the threaded rod, and slide it through the hole on the spider. Note that the top of the threaded rod will slip into this indentation on the spider. Next add the column, and turn upside down. Now place the base atop this column, making sure it is properly aligned. Now place the washer and nut on the threaded rod, as you screw the nut, make sure that you can feel that the top of the rod is locked inside the indentation on the spider…you may have to pull up and turn a bit. Tighten the nut, and your base is almost finished. Just screw the glides onto the base and you are done. To mount on the table, just place the base onto the center of the table top, making sure to measure, and attach with screws through the holes in the spider. Thank you for watching, and if you have any questions, please contact us!