Assembly instructions for the single column crank stand up desk. Parts included with single column crank stand up desk. Parts needed for step 1: Attach the single column crank (B) to the desk frame (A) with screws (jx5) using Allen wrench (Q). Make sure not to fully tighten until all screws are in place. Step 2: insert crank handle (E) the crank has supports pre-installed. Parts needed for Stop 3. Step 3: Align crank supports to their corresponding screw holes and use screws (Hx4) and fasten with Allen wrench (N). Parts needed for step 4. Step 4 Attach base frame (C) to single column crank frame (B) using screws (Jx3) and allen wrench (Q). Make sure all screws are tightened securely. Parts needed for Step 5. Step 5 finish fastening the base frame to the crank frame with screws Lx2 and washer (Px2) with allen wrench (Q). Fully tighten. Repeat for opposite side of frame, as well. Parts needed for step 6. Fasten casters to bottom of base starting with locking casters (Fx2) on longer end of base (front) with wrench (R). Step 6: then install the non-locking casters (Gx2) on the side closer to the crank shaft with wrench (R). Step 7 with assistance flip the desk upright. Place desktop D onto frame. Line up underlying desktop and frame screw holes. Step 8: fasten desktop with screws (Kx4) and allen wrench (M). Repeat for all 4 sides. To adjust the height of your desk simply pull the crank out and rotate counter clock wise to go up and clock wise to go down. Enjoy your new single column crank adjustable stand up desk!
Learn how quick and easy it is to assemble the Luxor Single Column Crank Stand Up Desk by watching this informative video!