Luxor Assembly Guide: 31.5" Wide Stand Up Workstation

Assembly instructions for the STANDUP-31.5-B 31 1/2" adjustable stand up workstation. Step 1a: Flip frame 1 upside down and screw locking caster (A) into longer side and non-locking caster (B) into shorter side with wrench (G). Step 1b: Repeats step 1a on frame (2). Step 2: If the threaded insert appears misaligned a screw driver may be required for realignment. With assistance, install the bottom shelf (5) into frames (1) & (2) with screws (Ex4) and wrench (H). Flip the unit over to install the next few supports. Step 3a: Install the cross support (4) into the screw holes on frames (1) & (2). Fasten using screws (Cx4) and allen wrench (H). Step 3b: Determine your desired height by following the chart. Insert the cross bar (3) into desired position. Fasten with screws (Dx4) and allen wrench (H). With assistance, flip the desk upright. Step 4a: Start with longer depth desk top (6). Place into lower portion of the top. Step 4b: Place short depth desk top (7) onto upper portion of top frame making sure the screw holes align properly. Step 4c: Insert screw (F) using allen wrench (H). Step 4d: Do the same with the top desk surface. Insert screw (F) using allen wrench (H). Assembly is complete!