$285.75/Each
This product is no longer available. We've left this page up for reference only.
Usually Ships in 6 Weeks from manufacturer
Lead times vary based on manufacturer stock
Not eligible for expedited shipping
Product Overview
- OEM part ensures warranty / agency compliance and best performance
- Quantity
- 1/Each
- Shipping Weight
- 1 lb.
- Spout Length
- 18 Inches
- Handle Type
- Lever
- Spout Type
- Swing
Customer questions about this product
Can the utility type, serial number, or production date of my equipment affect whether or not this part fits?
Sometimes, factors like the voltage, fuel type, and serial number may determine whether or not a particular part will fit your particular unit. We do our best to provide the most up-to-date information possible on our site but we cannot guarantee that this will clarify every possible scenario. If you require additional confirmation that this part is the correct one for your unit, we recommend consulting manufacturer literature and resources for your equipment to verify the correct part.
Is this an OEM part?
Yes. This is an OEM (Original Equipment Manufacturer) part.
What is the difference between an OEM part and an OEM-equivalent part?
An OEM part is the original component that was made for your equipment.
We also sell parts that are equivalent to OEM products, but are not genuine OEM. Each type has its own merits – these are some things to consider when making the decision between OEM and OEM-equivalent parts:
• Using an OEM part guarantees that you will comply with any valid manufacturer’s warranties and agency approvals on your product. An OEM-equivalent part may or may not offer the same guarantees.
• OEM-equivalent parts are built to the same specifications as the original part and are often available at a lower price point. In some cases it may even be sourced from the same location as the OEM part, though this will vary from item to item.
What measurements do I need to install a faucet?
When installing a faucet, these are some of the most common measurements you’ll need:
Faucet Centers: If your faucet has a base with 2 inlets, measure the distance from the center of one inlet to the center of the other. This number must match the spacing of your building’s water lines (adjustable centers will help with the spacing). If mounting through the backsplash on a sink, the center measurement must also fit within the pre-drilled mounting holes.
Flex Hoses: If your faucet has flex hoses make sure that they will reach your building’s water lines.
Spout length: Make sure that the faucet spout will fit comfortably over your sink bowl and not extend too far / not far enough. If you plan to use a swing spout over a multi-bowl sink, make sure it will reach all of the bowls.
Details
Legion 440026 18" Cold Spout/Fa.
Attention CA Residents: