• Free Shipping!  

$456.75/Each

Add to cart or login. (You can remove it at any time.)

Why do we do this?

  • Noise level: 51 dBA
  • Weighs only 10 lb.
  • Four level filtration
  • Two piece backplate for reduced stress
  • Includes Xover floor tool kit D (107100)
  • 7.2 amps (power mode) / 5.1 amps (quiet mode)

UPC Code:

400011135720

Condition:

New
Shipping:

Usually Ships in 1 Business Day
When will I receive my item?

You May Also Need

"You May Also Need" items are guaranteed to work with the item you are viewing, such as lids that will fit a cup or casters that will fit a piece of equipment. If an item is not listed in this section, we do not guarantee that it will work with the product you are viewing and do not recommend that you purchase them for use together.

View All Items
ProTeam Backpack Vacuum Maintenance

ProTeam Backpack Vacuum Maintenance

It's important to be aware of what repairs and maintenance fall under the product warranty and which repairs or maintenance is part of the product's normal wear and tear. Let's review the product's routine maintenance recommendations. Remember that the environment will determine how frequently filter maintenance is required. So, check filters before and after each use to determine if filters need to be emptied, cleaned, or replaced. ProTeam recommends that you keep a filter maintenance log which will enable you to keep track of your filter replacements. First, let's review ProTeam's filter maintenance. Prior to every use, check the Intercept Micro filter and Micro cloth filters. A clogged and dirty filter will restrict air flow and results in reduced suction and overheating. Prevent possible damage to the motor by simply changing or cleaning the filters frequently. Again, remember that the environment will determine how frequently filter maintenance is required. To maintain these filters, first take off the top cap and pull out the Intercept Micro filter and Micro cloth filter at the same time to avoid tearing the Intercept Micro filter, especially if the filters are very full. When emptying the Intercept Micro filter, carefully remove the filter from the vacuum body. Turn the Intercept Micro filter upside down into a garbage receptacle that has a plastic liner. Take the garbage receptacle liner and close around the filter opening so dirt and debris do not float into the air. Gently shake the filter into the garbage receptacle liner until empty. Make sure the pores of the Intercept Micro filter aren't clogged as fine dust can clog the filter even when it has been shaken out. If the filter is clogged, discard and use a clean Intercept Micro filter. Non-reusable filters need to be discarded when full and must be replaced with a clean, genuine ProTeam replacement filter. Check both filters for rips or tears and remember to replace filters as often as necessary. Once a month, or as necessary, hand or machine wash the Micro cloth filter and let it air dry. Do not put it in the dryer. Once a week, or as necessary, clean the dome filter. To access the dome filter, first remove the Intercept Micro filter and cloth filter, reach into the vacuum body, and pull the top piece of the dome filter off and remove the foam media. Shake it out, rinse, and air dry. Once dry, replace and firmly snap the top piece of the dome filter back into place. Next, reinstall the Micro- cloth filter. Make sure that the lip of the filter completely covers the rim of the vacuum. Never use the Intercept Micro filter without the Micro cloth filter, as the rubber gasket of the Micro cloth filter provides the vacuum seal. Next, install the Intercept Micro filter inside the Micro cloth filter. Replace the top cap and ensure that it is closed snugly. Once every two weeks, or as necessary, inspect the HEPA filters. When the filter becomes discolored, replace it with a new one. For best results, this filter should be replaced at least every six months. To inspect or replace the HEPA filter, depress the raised portion of the tab on the filter door and pivot the door away from the vacuum body. Grasp the plastic housing on the HEPA filter and remove it from the vacuum. To replace the filter door, align the two tabs to the housing, press in place, and rotate upward. Be sure to snap the locking tabs of the spring finger behind the tab of the housing. You should hear an audible click if it is installed correctly. The body can be wiped down with a wet sponge or cloth, but you must be careful not to get water on the motor. While vacuuming, stop every two hours or as needed to check, empty, or replace the Micro filters. Remember to only use genuine ProTeam replacement filters to ensure optimal performance. Please refer to the limited warranty section of your product's owner’s manual for detailed warranty information.

Copy and paste the embed code above.

Learn the correct way to inspect and clean your ProTeam backpack vacuum! By following a few specific instructions, you can ensure that your vacuum is always running optimally.

Specs
Cord Length 50 Feet
Handle Length 42 - 59 Inches
Hose Diameter 1 1/2 Inches
Amps 5.1 - 7.2 Amps
Voltage 120
Wattage 612 - 864 Watts
Capacity 6 qt.
Features HEPA Filtration
Noise Level 51 - 60 dB
Power Type Electric
Static Lift 45 - 82 Inches
Style Backpack
With Attachments Yes

Details

Quickly and quietly clean throughout your establishment with the ProTeam 107146 6 qt. QuietPro BP HEPA with Xover floor tool kit! Designed to effectively clean an array of surfaces without being obtrusive, its low 51 dBA noise level is quieter than many normal conversations, which typically register in the 50 to 60 dBA range. Because of its quiet sound, it is great for use during business hours, and its convenient back mounted design is ideal for cleaning under and around chairs, tables, and other furniture.

This vacuum boasts four level, HEPA filtration that can capture up to 99.97% of dust mites, pollen, bacteria, and other particulates that are 0.3 microns or larger in size. For maximum convenience, it comes with a 1 1/2" diameter static dissipating vacuum hose, 50 foot extension cord, and two replacement Intercept Micro filters.

Xover floor tool kit D includes:
- 14" Xover floor tool
- 42" to 59" aluminum telescoping wand
- 17" crevice tool
- 3" dust brush with reducer
- 5" upholstery tool

  • Carpet & Rug Institute - Bronze

    Carpet & Rug Institute - Bronze

    This item complies with the Carpet and Rug Institute's Bronze Performance Standard for proper soil removal, dust containment, and texture protection. This seal of approval ensures air quality and enhanced cleaning standards.

  • 5-15P

    5-15P

    This unit comes with a NEMA 5-15P plug.

Get paid to review this product!

If you've used this product, simply log in and share your text, video, and photo reviews of it. The customers on the left did it, and you can too! Earn up to $16.00 per product.

Login or Register