WEBVTT

1
00:00:10.500 --> 00:00:11.040
<v 0>In this segment,</v>

2
00:00:11.040 --> 00:00:14.430
we're going to discuss the installation of your front breathing kit for your

3
00:00:14.430 --> 00:00:16.710
Continental refrigerator or freezer sandwich unit.

4
00:00:17.250 --> 00:00:21.750
It's recommended that someone assist you in placing the cabinet on its

5
00:00:21.750 --> 00:00:25.350
back for the removal of the skid and the installation of the air ducts.

6
00:00:26.280 --> 00:00:30.930
Four blocks on each corner so that no damage is done to the exterior

7
00:00:30.930 --> 00:00:34.290
cover or the refrigeration lines. Once it is placed,

8
00:00:34.950 --> 00:00:36.880
remove the shipping bolts for the skid,

9
00:00:51.740 --> 00:00:53.160
and place the skid to the side.

10
00:00:55.950 --> 00:01:00.930
You will see the four inserts for your stem casters and the air ducts.

11
00:01:02.580 --> 00:01:07.560
Locate your air duct, and it's always important that the 

12
00:01:07.560 --> 00:01:08.700
access hole is at the rear.

13
00:01:09.360 --> 00:01:12.510
This allows the air to come in and go through the condenser coil.

14
00:01:13.200 --> 00:01:16.830
Place the air duct over the hole for the caster.

15
00:01:18.300 --> 00:01:21.870
Place the caster in the hole and thread it in place.

16
00:01:23.010 --> 00:01:24.900
Always being careful not to cross-thread.

17
00:01:45.210 --> 00:01:49.920
Be sure that the castor is firmly set to the bottom of the case to prevent any

18
00:01:49.920 --> 00:01:54.840
bending or caving in. Do the same thing on the other side.

19
00:01:56.100 --> 00:02:01.050
Make sure your air ducts, the holes are facing the rear and secure

20
00:02:01.050 --> 00:02:02.883
<v 1>your two casters.</v>

21
00:02:06.260 --> 00:02:08.040
After the air ducts are installed

22
00:02:08.040 --> 00:02:12.150
<v 0>and the casters are firmly attached to the bottom of the cabinet</v>

23
00:02:12.480 --> 00:02:16.980
and flush to the bottom of the cabinet, take your grill, place it over the front,

24
00:02:20.070 --> 00:02:21.840
and secure with the two thumb screws.

25
00:02:29.100 --> 00:02:31.680
Once the grill of the air ducts and the casters are in place,

26
00:02:31.890 --> 00:02:36.000
the unit now can be set upward with the assistance of someone else.

27
00:02:36.030 --> 00:02:39.780
When the front breather is installed properly and the unit is set back in

28
00:02:39.780 --> 00:02:40.830
its upright position,

29
00:02:41.400 --> 00:02:44.460
inspect and make sure that everything is good and that the unit is level.

30
00:02:44.880 --> 00:02:48.870
It can now be placed under the counter or in a position with minimal clearance

31
00:02:48.870 --> 00:02:50.940
on the sides, rear, and top.

32
00:02:51.630 --> 00:02:56.580
The purpose of the front breather is to draw fresh air in from the front left,

33
00:02:56.880 --> 00:03:01.570
goes through the condensing unit, and discharges out the front right. This way

34
00:03:01.570 --> 00:03:04.450
you don't need the clearance that you would if you did not have the 

35
00:03:04.450 --> 00:03:07.270
front breather. If additional information is needed,

36
00:03:07.360 --> 00:03:09.250
consult the operation manual on the

37
00:03:09.250 --> 00:03:12.730
website at www.continentalrefrigerator.com.