Hi, I'm Kevin Resnick. I work with Spaceman USA. Thank you for purchasing one of our machines. Today I'm going to show you about the buttons. We're going to take some product out, and we're going to clean it out and we're going to put product back in. The first one is going to be your power button. This is going to give power to your display. The second button is going to be your freeze button. This will freeze product throughout the day. The next one is your wash, which is going to beat the product and just spin the augers. Then you have sleep mode, which you'll use through the night. Reset, or the stop button. Your ice cream button which is going to show your dispenses in the day, and P, which is used for various purposes. But the first time you press P, it's going to give you the temperatures on the hoppers and the cylinders, and when the motor is running, it will give you the current of the motor. We have product that's been made in this machine right now. We're going to start by flushing it out and getting ready to pull off the discharge door. The first thing that we want to do is remove the hopper covers and the air tubes. And we'll take these to the sink. We're going to pour a little bit of water in the hoppers, about a gallon in each side, and we're going to flush out the product that's remaining in the machine. Press wash on the front and that's going to agitate the mix. We'll use our brush and we'll just scrub along the sides and break free any debris. We've had it on wash now for approximately a minute. We're going to pull down the handles and remove the product. Once you've removed all the mix, you'll want to press the reset button, which is going to stop the beaters from spinning. Then we'll do a second rinse just to make sure we get everything as clean as we can. No you're ready to disassemble the discharge door.
Check out this video for a brief introduction to the Spaceman USA Ice Cream Machine.