$349.99/Each


Our Item #:
413C7 208/3
Units:
EA
Shipping
Ships via Common Carrier
Usually Ships 1 Business Day
When will I receive my item?
Outlet Policies

Details

  • New; never used
  • Dents on lower front left corner, left side top edge, right side, and back side
  • Technician tested; guaranteed to work perfectly upon arrival

The space saving Hatco C7 7 kW compact booster water heater has a 6 gallon capacity to provide plenty of hot final rinse water required to properly sanitize and flash-dry dishes and flatware.

The Hatco C7 electric booster heater is factory pre-plumbed and pre-wired with a calibrated immersion thermostat and high-temperature limit switch. Fiberglass insulation minimizes heat loss, while the stainless steel front panel and powder coated body provide long-lasting durability. Swing-away front panels with low-water cut-off, control fuses, and transformer allow quick access to probes and elements for easier servicing.

The Hatco C7 compact booster heater is UL and NSF Listed. Choose voltage. Please consult the Specification Sheet for additional details and important installation requirements. A sizing chart is included at the end of the Spec Sheet to help you match the correct booster heater to your needs.

Water Quality Requirements: Incoming water exceeding 3.0 grains of hardness per gallon (GPG) must be treated and softened before being supplied to the booster heater. Water containing over 3.0 GPG will decrease the efficiency and reduce the operating life of the unit. Product failure caused by liming or sediment buildup is not covered under warranty.

Dimensions & Specs:
Overall: 13"W x 20 3/4"D x 19 3/4"H (includes legs)
Water Temperature Recovery @ 40 Degrees Fahrenheit Rise: 70 GPH
Water Temperature Recovery @ 70 Degrees Fahrenheit Rise: 40 GPH

Please Note: Only 208/1, 208/3, 240/1, and 240/3 Volt options are available for Quick Ship

This Item Ships via Common Carrier. For more information and tips to help your delivery go smoothly, click here.